US English
10
100
Drain any liquids from the drip tray and place it back into
the machine. Press the "OK" button.
Check that the Cappuccinatore is placed in the machine.
Press the "OK" button.
Place a container under the hot water wand and a large
container under the Cappuccinatore. Press the "OK"
button.
The machine performs the rinse cycle.
A default amount of water
is needed for the rinse
phase. This allows an ideal
rinse cycle to be
performed in order to
ensure the best conditions
to brew products. A
message to fill the water
tank will be displayed
throughout the rinse cycle.
This is normal and part of
the procedure.
The rinse cycle may be
paused by pressing the
"ESC" button; to resume
the cycle, press the "OK"
button. This allows you to
empty the container or to
leave the machine
unattended for a short
time.
Once the rinse cycle has been completed, the machine
carries out the circuit priming, the warm-up and rinse
cycle in order to be ready for product brewing.
To Next Page
Loading...
