TS7000 MATERIAL HANDLER OPERATORS MANUAL - VERSION I
Page 17
Figure 9 Figure 10
If the calibration screen has been entered by accident and touch calibration is not necessary,
press the Exit button without pushing anywhere else on the screen. This process exits the
touch screen calibration and continues with the standard start up procedure.
If touch calibration is required, follow the below procedures:
Press and hold finger where the two lines meet inside the small box (Figure 10 bottom left
hand corner). Calibration works fine when using a finger but for better results use a pen taking
care not to press too hard or the screen will be damaged.
Hold finger/pen in this area until prompted to lift (Figure 9). The software will then prompt for
three more touch zones resulting in co-ordinates for all four corners of the screen.
Once calibration is complete the software automatically begins the standard start up
procedure.
To Next Page
Loading...