TS7000 MATERIAL HANDLER OPERATORS MANUAL - VERSION I
Page 20
KEYSWITCH OVERRIDE – FIGURE 15
Figure 15
The Override Keyswitch is located on the right side of the M400 Motherboard box. The key
can be removed when the override is not engaged once the override is engaged the key
cannot be removed and the display will show Keyswitch Override E05 or E055
This switch is used to override the cut out so should only be done under supervision
as a last resort.
FUSES – FIGURE 16
All the outputs and the voltage in are protected by standard blade fuses.
Figure 16
1. 2 Amp Main System Fuse
2. 5 Amp Keyswitch Override Fuse
3. 5 Amp Dump Fuse
4. 5 Amp Relay #2 Fuse
5. 5 Amp Relay #3 Fuse
6. 5 Amp Relay #4 Fuse
To Next Page
Loading...