Error! Style not defined.
10
VPI: Virtual path between two points in an ATM network. Its
valid value range is from 0 to 255.
VCI: Virtual channel between two points in an ATM network.
Its valid value range is from 32 to 65535 (1 to 31 are reserved
for known protocols).
Service Category: UBR Without PCR/UBR With
PCR/CBR/Non Realtime VBR/Realtime VBR.
Enable Quality Of Service: Enable or disable QoS.
After proper modifications, click Next and the following page
appears.
Step 2 In this page, you can modify the Internet connection type
and encapsulation type.
Change the connection type of PVC 0/35 to PPP over Ethernet
(PPPoE) and set the Encapsulation Mode to LLC/SNAP-BRIDGING
(according to the uplink equipment). Click Next and the following
page appears.
Step 3 In this page, you can modify the PPP user name, PPP
password, authentication method.
Error! Style not defined.
11
PPP Username: The correct user name that your ISP provides to
you.
PPP Password: The correct password that your ISP provides to you.
PPPoE Service Name: If your ISP provides it to you, please enter it.
If not, do not enter any information.
Authentication Method: The value can be AUTO, PAP, CHAP, or
MSCHAP. Usually, you can select AUTO.
Dial on demand (with idle timeout timer): If this function is
enabled, you need to enter the idle timeout time. Within the preset
minutes, if the modem does not detect the flow of the user
continuously, the modem automatically stops the PPPOE connection.
Once it detects the flow (like access to a webpage), the modem
restarts the PPPOE dialup.
If this function is disabled, the modem performs PPPOE dial-up all
the time. The PPPOE connnection does not stop, unless the modem
is powered off and DSLAM or uplink equipment is abnormal.
To Next Page
Loading...
Need help?
General
