6101
6101
6101
6101 Belt
Belt
Belt
Belt Scale
Scale
Scale
Scale Integrator
Integrator
Integrator
Integrator Operating
Operating
Operating
Operating and
and
and
and Service
Service
Service
Service Manual
Manual
Manual
Manual
50
When “ SURE ZERO ” is pressed, the following prompt message is displayed.
Note: Duringg auto zeroing process, belt must be running, cause complete zeroing process
needs one revolution of belt running. I f there is error in connection of sensor, or signal
vibrates too large, then below menu will be displayed(please check for fault)
If p res
s
“ MANL ZERO ” soft key to enter the “ Manual Zeroing ” menu.
“ MANL ZERO ” allows direct input via key board and changing scale zero
2010-11-09 12:00:00 Scale#1
0.00 t
0.00t/h
1m/s
Main: Run belt empty, select an option.
BGIN EXIT
ZERO ZERO
2010-11-09 12:00:00 Scale#1
8 000000 t
t/h
1m/s
Zero failure, exceed zero range ！
BGIN EXIT
ZERO ZERO
2010-11-09 12:00:00 Scale#1
8 000000 t
888 t/h
1m/s
Run belt empty, select an option.
AUTO EXIT MANL
ZERO ZERO ZERO
To Next Page
Loading...