6101
6101
6101
6101 Belt
Belt
Belt
Belt Scale
Scale
Scale
Scale Integrator
Integrator
Integrator
Integrator Operating
Operating
Operating
Operating and
and
and
and Service
Service
Service
Service Manual
Manual
Manual
Manual
88
Chapter
Chapter
Chapter
Chapter 4.0
4.0
4.0
4.0 Integrator
Integrator
Integrator
Integrator Maintenance
Maintenance
Maintenance
Maintenance
4.1
4.1
4.1
4.1 Service
Service
Service
Service and
and
and
and Repairing
Repairing
Repairing
Repairing
Generally belt scale is comprised of weighbridge, speed sensor and integrator.
M aintenance info. covered by this manual will meet your requirement. I
f
technical support is
needed, please dial 086-0516-87885888 （ 87885858 ） for assistance. T o respond to your
questions quickly, please wirte down your machine model and relative data.
4.2
4.2
4.2
4.2 Daily
Daily
Daily
Daily Maintenance
Maintenance
Maintenance
Maintenance Routines
Routines
Routines
Routines of
of
of
of 6101
6101
6101
6101 Integrator
Integrator
Integrator
Integrator
Often observing the operation situation of the device c an find potential faults in time ,
if
indeed there is a problem, please follow the troubleshooting steps to check :
A. Check power supply
· Check that the voltage selector switch is set to the correct position.
·
Check that the fuse is good.
· Check that the power is switched ON to energize the 6101.
B. Check all wire connections carefully.
· Check that all the terminals are tightly connected.
· Check that the remote counter and the optional input/output module are firmly
plugged in system slots.
·
Check that the display board and keypad interface is secured.
· Check that all the jumpers are set correctly.
C. Check all wire connections carefully.
· Check that all the terminals are tightly connected.
·
Check that the remote counter and the optional input/output module are firmly
plugged in system slots.
· Check that the display board and keypad interface is secured.
· Check that all the jumpers are set correctly.
4.3
4.3
4.3
4.3 Troubleshooting
Troubleshooting
Troubleshooting
Troubleshooting ---
---
---
--- Fault
Fault
Fault
Fault Isolation
Isolation
Isolation
Isolation
To locate the fault of the belt scale, a specified troubleshooting routine should be executed.
The following troubleshooting flow chart (Figure 4-1) helps understand the operation of the
system, and locate the trouble component among the following hardware accordingly.
· Power supply assembly
load cellS peed sensor
I ntegrator
To Next Page
Loading...