Saimo 6105 - 6105 Integrator Installation; General Installation; Mounting and Safety Precautions

6105
6105
6105
6105 Belt
Belt
Belt
Belt Feeder
Feeder
Feeder
Feeder integrator
integrator
integrator
integrator ---
---
---
--- User
User
User
User ’
’
’
’ s
s
s
s Guide
Guide
Guide
Guide ---
---
---
---
17
Use the same method as described in section 5.3.1.2 to set the digital value for each variable.
P to test hi (Pivot to test weight height): Min:0 Max:250mm
P to test le (Pivot to test weight length): Min:0 Max:250mm
P to carry (Pivot to carriage height): Min:0 Max:250mm
R to carry (Carry roll to carriage height):Min:0 Max:250mm
5.3.1.4
5.3.1.4
5.3.1.4
5.3.1.4 Initial
Initial
Initial
Initial Setup
Setup
Setup
Setup 3
3
3
3
Press “ PAGE DOWN ” soft key from the Initial Setup 2 Menu described in Section 5.3.1.2, the first page
of Initial Setup 3 Menu is displayed as follows:
Use the same method as described in section 5.3.1.2 to set the digital value for each variable.
#of Loadcells : Min:1 Max:6
Idler Spacing : Min:50 Max:2500mm
Conveyor Angle : Min:-25 Max:25
Loadcell Cap : Min:1kg Max:5000kg
2006-3-21 12:00:00 Scale #1
INITIAL SETUP 3
# of Loadcells: [ 1 ]
Idler Spacing: [ 100mm ]
Conveyor Angle: [ 10 ]
Loadcell Cap: [ 100 kg ]
Press
↑
or
↓
key, then press ENT!
MAIN PAGE PAGE
MENU DOWN UP
2006-3-21 12:00:00 Scale #1
SCALE CODE DATA 3
P to Test High: [ 100mm ]
P to Test Len: [ 100mm ]
P to carry: [ 100mm ]
R to carry: [ 100mm ]
Press
↑
or
↓
key, then press ENT!
MAIN PAGE PAGE
MENU DOWN UP