6105
6105
6105
6105 Belt
Belt
Belt
Belt Feeder
Feeder
Feeder
Feeder integrator
integrator
integrator
integrator ---
---
---
--- User
User
User
User ’
’
’
’ s
s
s
s Guide
Guide
Guide
Guide ---
---
---
---
18
Press “ PAGE DOWN ” soft key from the Initial Setup 3 Menu described in Section 5.3.1.4, the first page
of Initial Setup 4 Menu is displayed as follows:
Use the same method as described in section 5.3.1.2 to set the digital value for each variable.
Sensitivity: Min:0.5 Max:3.5
#1 load cell resistor: Min:0 Max:350
#2 load cell resistor: Min:0 Max:350
#3 load cell resistor: Min:0 Max:350
5.3.1.5
5.3.1.5
5.3.1.5
5.3.1.5 Initial
Initial
Initial
Initial Setup
Setup
Setup
Setup 5
5
5
5
Press “ PAGE DOWN ” soft key from the Initial Setup 4 Menu described in Section 5.3.1.4, the fifth page
of Initial Setup Menu is displayed as follows:
Use the same method as described in section 5.3.1.2 to set the digital value for each variable.
#4 load cell resistor: Min:0 Max:350
#5 load cell resistor: Min:0 Max:350
#6 load cell resistor: Min:0 Max:350
Weight channel: Channel 1, Channel 2, Dual
2006-3-21 12:00:00 Scale #1
INITIAL SETUP 5
4# Resistor: [ 350 Ohms]
5# Resistor: [ 350 Ohms]
6# Resistor: [ 350 Ohms]
Weight Channel: [ CHANNEL 1 ]
Press
↑
or
↓
key, then press ENT!
MAIN PAGE PAGE
MENU DOWN UP
2006-3-21 12:00:00 Scale #1
INITIAL SETUP 4
Sensitivity: [ 3 mv/v ]
1# Resistor: [ 350 Ohms]
2# Resistor: [ 350 Ohms]
3# Resistor: [ 350 Ohms]
Press
↑
or
↓
key, then press ENT!
MAIN PAGE PAGE
MENU DOWN UP
To Next Page
Loading...