6105
6105
6105
6105 Belt
Belt
Belt
Belt Feeder
Feeder
Feeder
Feeder integrator
integrator
integrator
integrator ---
---
---
--- User
User
User
User ’
’
’
’ s
s
s
s Guide
Guide
Guide
Guide ---
---
---
---
19
Note: When Dual channels are used for the weight channel, the two load cells should be connected to
the channel 1 and channel 2 separately on the A/D board.
5.3.1.6
5.3.1.6
5.3.1.6
5.3.1.6 Initial
Initial
Initial
Initial Setup
Setup
Setup
Setup 6
6
6
6
Press “ PAGE DOWN ” soft key from the Initial Setup 5 Menu described in Section 5.3.1.5, the sixth page
of Initial Setup Menu is displayed as follows:
Note: the setting value of the speed mode is “ S imulate d ” and “ A c tual ” . When “ Simulated ” is selected,
the integrator will generate an analog signal for speed input. In case that “ Act ual ” is selected, the speed
input is an actual speed signal. Simulation allows operation without a speed sensor.
There are two channels for selection: Channel 1 and Channel 2.
5.3.1.7
5.3.1.7
5.3.1.7
5.3.1.7 Establishing
Establishing
Establishing
Establishing Test
Test
Test
Test Duration
Duration
Duration
Duration
Press “ PAGE DOWN ” soft key from the Initial Setup 6 Menu, the first page for establishing test duration
appears.
2006-3-21 12:00:00 Scale#1
8 000000 t
888 t/h
1m/s
Establish test duration!
AUTO MANL PAGE
DURA DURA UP
2006-3-21 12:00:00 Scale#1
INITIAL SETUP 6
Speed Mode: [ SIMULATE ]
Speed Channel: [CHANNEL 1]
Press ↑ or ↓ key, then press ENT!
MAIN PAGE PAGE
MENU DOWN UP
To Next Page
Loading...