• Wind Gust
• Wind Average
• Rate Rainfall
• 24 Hour Rainfall
• Absolute Pressure
• Relative Pressure
• Indoor Temperature
• Indoor Humidity
• Indoor Dew Point
• UV Index
• Sunlight
8.1 Alarm Operation
When an alarm condition is exceeded, the alarm icon will flash (visual) and the alarm
beeper will sound (audible). To silence the beeper, press any key.
8.2 Viewing the High and Low Alarms
To view the current alarm settings, press the ALARM key to enter the alarm mode. HI AL
1 will be displayed in the date area. At the same time Alarm 1 time and HI alarm parame-
ters of indoor temperature/humidity, outdoor temperature/humidity, rain rate, AT, feels
like, wind gust, wind average, absolute pressure, UV index, Sunlight are displayed. Press
SET/MODE key to view Alarm 2 time and HI alarm parameters of indoor dew point, 24h
rainfall, outdoor dew point, and relative pressure.
Press ALARM key again to view the LOW alarms along with the alarm clock time the
same way HI alarms.
Press the SNOOZE key at any time to return to the normal mode.
8.3 Setting the Alarms
Press ALARM key to enter the alarm mode.
Press and hold the SET/MODE key for three seconds. The first alarm parameter will begin
flashing (alarm hour).
To save the alarm setting and proceed to the next alarm parameter, Press (do not hold) the
SET/MODE key.
To adjust the alarm parameter, press the [+] or [-] key to increase or decrease the alarm set-
tings, or press and hold the [+] or [-] key for three seconds to increase or decrease the
alarm settings rapidly.
Press the ALARM key to turn on (the alarm icon will appear) and off the alarm.
Press the SNOOZE key once at any time to return to the normal mode. After 30 seconds of
inactivity, the alarm mode will time out and return to normal mode.
The following is a list of the individual alarm parameters that are set (in order):
1. Alarm hour(alarm 1)
To Next Page
