Sainlogic WS0310 - Page 24

- 24 -
Max/Min can be programmed to clear daily (at midnight) or
manually. Press the CHANNEL/+ key or MAX/MIN/- key to
switch between ON (Clears 24h) and OFF (Manually).
10. Temperature Units of Measure (default: °F):. Press the
SET/MODE key again to change the temperature units of
measure. Press the CHANNEL/+ key or MAX/MIN/- key to
switch between °F and °C units of measure.
11. Wind Speed Units of Measure (default: mph). Press the
SET/MODE key again to change the wind speed units of
measure . Press the CHANNEL/+ key or MAX/MIN/- key to
toggle the wind speed units between m/s, km/h, mph, knots bft
or ft/s.
12. Rainfall Units of Measure (default: in). Press the
SET/MODE key again to change the Rainfall units of measure.
Press CHANNEL/+ key or MAX/MIN/- key to toggle the rainfall
units between mm and inch.
13. Barometric Pressure Display Units(default: InHg).
Press the SET/MODE key again to change the pressure units
of measure. Press the CHANNEL/+ key or MAX/MIN/- key to
toggle the pressure units between mmhg, inHg or hPa.
14. Pressure Threshold Setting (default level 2). Press the
SET/MODE key again to change the pressure threshold. Press
the CHANNEL/+ key or MAX/MIN/- key to change pressure
threshold 2 hPa to 4 hPa. (For detailed information of this part
please refer to 10.5)
15. Weather Icons Setting (default: partly cloudy). Press
the SET/MODE key again to change the initial weather icon.
Press the CHANNEL/+ key or MAX/MIN/- key to select the