SainSmart Genmitsu - Y-Axis Limit Switch Wiring

30
Part 2: Mechanical installation
NAME QTY.
Step 21: Wiring Connecting wires (Y Axis Limit Switch)
NO.
Operation
Steps
Prepare
materials
VIEW 1
VIEW 2
CODE
Tools
Check
Remind
Limit Switch Connecting wire
Y LIM + 30cm
Limit Switch Connecting wire
Y LIM - 60cm
Sealing strip 270mm (Y Axis)
1
1
3
2
1
1
1
1
2
MX3-31
MX3-32
MX3-47
Put Limit switch connecting wire insert the Control board
and Limit switch, the switch near by the motor is the LIM+.
Use the Sealing strip to cover the wires MX3-32 inside
the Aluminum Profile.
Pay attention the mark on the Control board, make sure
the correct sequence and direction of the connectors.
MX3-31
MX3-32
MX3-47
use here