TROUBLESHOOTING
6.6 Revised 5/19/2010
65
RUN ABORTED
RUN ABORTED DUE TO
UNPARALLEL GRIPPER
ARMS
Run aborted due to unparallel gripper arms (bending
upwards/failed to block sensor/bending downwards). Touch OK
98
POWER ā ON
PROBLEM
COULD NOT POWER ON
THE INSTRUMENT
Could not Power On the instrument. Clear all base molds
and empty output doors while this message is displayed.
PLEASE DO NOT TURN OFF THE MACHINE. Contact
Sakura Service Department for further instructions.
Contact Sakura
Service Department
100
AMBIENT
TEMPERATURE
PROBLEM
AMBIENT TEMPERATURE
EXCEEDS ACCEPTABLE
OPERATING
TEMPERATURE
Ambient Temperature exceeds operating requirements.
Embedding Stopped, until ambient temperature lowered.
To Next Page
Loading...