Sakura Tissue-Tek Film 4740 User Manual

Revised 08/08/2013 2.1
Section 2
INSTALLATION
General Information
This section provides detailed installation and setup
instructions for the Tissue-Tek
®
Film
®
Automated
Coverslipper. The installation steps must be followed
correctly to ensure proper operation and service. Read
this operating manual carefully before attempting to
operate the instrument. Follow all instructions carefully.
The Tissue-Tek Film Coverslipper is a precision
instrument and must be handled accordingly. Rough
handling or dropping the instrument will disturb or damage
internal components. Always handle the instrument with
care.
Select a place where sufficient clearance can be
provided around the instrument. Ample working space is
necessary in front and on top of the instrument.
Environmental Factors
As with all sensitive electronic instruments, prolonged
exposure to excessive humidity and temperature should
be avoided. Temperature and humidity should be held
relatively constant. The ambient temperature for operating
the instrument is 10º C to 40º C (50º F to 104º F). The
ambient operating humidity range is 30-85% relative
humidity.
Unpacking
Removing the Outer shipper
The Tissue-Tek Film Coverslipper is packaged in a
sturdy cardboard shipping carton attached to a wooden
pallet (Figure 2-A).
Figure 2-A
1. Inspect the carton and make sure there are no visible
signs of damage. If visible signs of damage are
evident, immediately file a complaint with the carrier
and notify Sakura Finetek USA Technical Support
Department. In countries other than the USA, contact
the nearest authorized Sakura distributor or
representative.
2. If no visible signs of damage are evident, remove the
protective tie wraps securing the outer shipper box to
the pallet (Figure 2-B).
Figure 2-B

Sakura Tissue-Tek Film 4740 Specifications

General

Brand	Sakura
Model	Tissue-Tek Film 4740
Category	Medical Equipment
Language	English