Salus RT310 Installation Manual

RESET
5
Select increment. Press
Installer Mode
Press and hold and and keys to enter installation setting.
The first setting is temperature display resolution selection - d01. Press to enter the existing setting. The
setting will start flashing. Press or to change temperature display resolution, wait for 10 seconds to
confirm, then enter d02 (if you didn’t press to save your selection, the change will be confirmed after 10
seconds and the thermostat will return to normal mode). d02 is to set temperature offset, press or to
increase/decrease offset.
To exit Installer Mode don’t press any key for 10 seconds, or press
See the table below.
RESET
Press the three buttons
together for 3 seconds.
3 Sec 3 Sec
3 Sec
dxx Function Parameter Description Default
value
d01 Temperature display
increments
0.1°C or
0.5°C
Select the temperature display
increments
0.5°C
d02 Temperature offset +/-3.0°C Calibrate your thermostat tempera-
ture
0.0°C
d03 Frost setpoint temperature 5.0°C-17.0°C Set the Frost Point temperature 5.0°C
Enter first d01 setting. Press
2
Continue adjusting the d02 and d03 following the same steps as above.
Once you have finished setting up all the parameters, press to exit
to home screen, or don’t press any button for 10 seconds and it will
exit automatically.
TESTING/PAIRING
TESTING/PAIRING
08 RT310 Installation Manual

Salus RT310 Specifications

General

Display	LCD
Power Supply	2 x AA batteries
Frequency	868 MHz
Temperature Accuracy	±0.5°C
Switching Voltage	230V AC
Protection Class	IP30
Programming	7-day programmable
Communication Protocol	RF
Range	30m (open space)
Temperature Range	5 - 35°C