34 Product Support 1-888-202-9831
G. TROUBLESHOOTING
Question or Problem Solution
1. How to determine if As confirmation that the device is delivering ultrasound,
the device is delivering the LEDs on the Power Controller will illuminate blue
treatment (treatment timer and indicator LEDs) and the indicator LED
on the applicator will illuminate blue. See section 8 on
LED Display.
2. The indicator LED on Ensure that the applicator is fully connected to the power
the Applicator does not controller wire jack and/or the Y-adapter wire jack. If
illuminate when the recently in sam Sensing Mode, ensure that the applicator
device is turned ON has had time to reach normal operating temperature and
the indicator LED on the applicator has turned from red
back to blue. If the applicator LED still fails to illuminate
blue, contact the manufacturer with serial and model
number details.
3. How to observe the The Battery Indicator display can only be viewed when
Battery level during the device is powered ON or OFF by pressing the Power
treatment Button, or when the Toggle Button is pressed. (See section
11.1) The lights remain illuminated for approximately 4
seconds after the device is turned ON or OFF. The Battery
Indicator LEDs do not remain illuminated during treatment.
The treatment duration is indicated by the blue treatment
timer LEDs (See section 8 on LED display).
To Next Page
Loading...
