3. Installation and Operation
SAM4S ER-180U SERIES 3-7
3-2 Operation
3-2-4 All Clear
This step insures that the cash register is cleared of any totals or programming. After this procedure, the cash
register is ready for programming and operation.
WARNING:This is a one time procedure. Do not repeat this procedure after the cash register is
programmed, it causes all programs and totals to be erased and to be default.
1. Unplug the register.
2. Press and hold the key position where the “CHARGE” key is located on the default keyboard layout.
3. Continue to hold the “CHARGE” key while plugging the register into a power source.
4. Press the upper left key of the keyboard, then the lower left key, then the upper right key, and finally press
the lower right key.
Figure3-4. All Clear Key Sequence & Print Sheet
03/18/2015 WED 19:20
= = = = = = = = = = = = = = = =
RAM ALL CLEAR OK !
= = = = = = = = = = = = = = = =
MEMORY 1 OK
MEMORY 2 OK
ER-180U EPROM INFO.
VERSION : STD 01.000
CHECKSUM : C85F
MAR 18 2015
CLERK 00 000001 000000
To Next Page
Loading...
