Sam4s ER-180U Series - Getting Started; Unpacking and Initial Setup

2. Product Specifications
2-2 SAM4S ER-180U SERIES
2-1 General Specification
B. Printer Specification
Item Description Remark
Model
•
LTP01-245-11 (SII)
Print Method
• Thermal Direct Line Printing
Printing Format
Total Number of Dots
• 384 Dots
Dot Pitch
• Vertical : 0.125 mm
• Horizontal : 0.125 mm
Printing Speed
•
65mm/Sec (8 Dot)
Printing Direction
• Unidirectional friction feed
Paper Feeding
Feeding Method
• Friction Feed
Minimum Feed Pitch
• 0.0625 mm
Feeding Speed
• 65 mm/Sec (At 7.5V of motor voltage)
Power Supply Volt
Power Voltage
• 4.2~9.5V (Recommend)
Head/Motor
Circuit Input Voltage
•
3.3V
Head Control/Sensor
Printer Head
Heat Element Density
• 8 Dots/mm (0.125mm/Dot ; 200 dpi)
(1step 0.0625mm)
Total Head Elements
• 384 Dots/Dot Line
Available Printing Width
• 48 mm
Line Feed Motor
• 2-2 Phase Bi-Polar Stepping Motor
Sensor
Head Temperature
• Thermistor
Paper-End Sensor
•
Reflection type photo interrupter
Reliability Life
• 50km or more
Dimension (mm)
• 70.3 (W) ×32.7 (D) ×15.3 (H)
Weight
• Approx. 44 g
Table2-2 Thermal Printer Specification
C. Paper Specification
Item Description Remark
Paper Type
• Single-ply Thermal Paper Roll
Paper Size
• 1 station 57.5 ±0.5 mm (Width) × diameter Ø 80 mm or less
Specified Paper
• Original Paper No : HPK-110 (Hansol paper XT)
Table2-3 Paper Specifications
Note: The following paper can be used instead of the specified paper above.
TF50KS-E: Nippon paper industries Co.,Ltd.
PD 160R : New Oji paper Mfg, Co.,Ltd. , F380 : Kansaki specialty papers, Inc. (USA)
D. Character Specification
Item Description Remark
Character Structure
• 12(W) × 24(H) Font (Including a horizontal)
Character Size
• 1.5 mm(W) ×3.0 mm(H)
Column Pitch
• 2.0 mm
Line Pitch
• 3.5 mm (Including 8-dot line spacing)
Number of Column
• 24 (12×24 Dots/Character)
Table2-4 Character Specification