16
G Series Receipt Printer
The sensor has five sensitivity
settings.
1. Push the open button and
open the printer cover.
2. If you find there is too
much paper remaining
when the sensor is
triggered, set the near end
sensor to position #4 or #5.
3. Decrease the setting if the
paper runs out before the
sensor is triggered.
APPENDIX
2
CHAPTER
2.1. Adjusting the Paper Near-End Sensor Location
NOTES : Paper core diameter varies by paper manufacturer.
The accuracy of the Near-End sensor depends on the adjustment scale
setting and the winding core diameter of the roll paper.
The Near-End sensor is set at adjustment #3.
This is the appropriate scale for the recommended paper thickness.
The factory default setting is at position #3.
To Next Page
Loading...
