Sam4s giant 100 series - Overview

4
CHAPTER 1
1.1. Overview
This document contains how to install/uninstall an SAM4S printer with an
interface and contains how to configure an SAM4S printer.
See below on installing SAM4S printer.
1. Verify interface of SAM4S printer (p.8).
2. Install proper SAM4S printer driver.
1) In case of a serial printer (p.10).
2) In case of a parallel printer (p.12).
3) In case of an USB printer (p.14).
4) In case of an USB to Serial printer (p.19).
5) In case of an Ethernet printer (p.24).
3. Make sure installed printer is properly works (p.26).
To uninstall a printer, refer (p.29).
The SAM4S printer driver installer (V2.0.2 or above) supports following models:
1. ELLIX10 (32bit only)
2. ELLIX20 (32bit only)
3. ELLIX20II (32bit / 64bit)
4. ELLIX30/30III/40 (32bit / 64bit)
5. ELLIX35/35III/45 (32bit / 64bit)
6. ELLIX32/42/37 (32bit / 64bit)
7. ELLIX40BlackMark (32bit Only)
8. GIANT-100 (32bit / 64bit)
9. GIANT PRO (32bit / 64bit)
The SAM4S printer driver installer is supported English and Korean.
»
»
Refer to 1.2. Operating Environment
Getting Started
1
CHAPTER