Sam4s giant 100 series - Verify Interface Type of SAM4 S Printer

CHAPTER 2
8
2.1. Verify interface type of SAM4S printer
Check the interface of printer from the ‘Self-Test’. The self-test checks the
following:
1. Make sure paper roll has been installed properly.
2.②
Turn on the power while
①
holding down the FEED button.
The self-test begins.
pic1) ELLIX20 / ELLIX20II
pic2) ELLIX30 / ELLIX40 / ELLIX35 / ELLIX45
Installation of
SAM4S printer
2
CHAPTER