EB 2517 EN 25
Measures for preparation before installation
Fig.5: Schematic drawing of lifting points on
the regulator
4.2.3 Storage
Risk of regulator damage due to improper
storage.
− Observe storage instructions.
− Avoid long storage times.
− Contact SAMSON in case of different stor-
age conditions or long storage periods.
NOTICE
!
We recommend regularly checking the regu-
lator and the prevailing storage conditions
during long storage periods.
Storage instructions
– Protecttheregulatoragainstexternalin-
uences(e.g.impact).
– Do not damage the corrosion protection
(paint, surface coatings). Repair any
damage immediately.
– Protect the regulator against moisture
and dirt. Store it at a relative humidity of
lessthan75%.Indampspaces,prevent
condensation. If necessary, use a drying
agent or heating.
– Make sure that the ambient air is free of
acids or other corrosive media.
– The permissible storage temperature of
standardregulatorsis–20to+65°C(–4
to+149°F).
– Do not place any objects on the
regulator.
Note
To Next Page
Loading...
