Samson 3510 - Actuator Nameplate; Material Number

EB 8091-1 EN 11
Markings on the control valve
The details on the valve version are lasered
onto the valve body (see Fig.1).
2.2 Actuator nameplate
See associated actuator documentation.
2.3 Material number
The valve are marked as follows:
Seat
− Material number
− SAMSON consecutive number
Plug
− Material number
− SAMSON consecutive number
− K
VS
coefcient and characteristic
Anti-rotation xture (on the trim)
Î See Fig.2
− Plug material
− Seat material
− K
VS
/C
V
− Characteristic
− SAMSON consecutive number
Anti-rotation xture (on the bellows seal)
− Bellows material
− Nominal pressure
Incorrect control due to a combination of
trim parts that do not match each other.
The trim parts (seat, plug, anti-rotation x-
ture, and body gasket) are matched to ex-
actly t each other.
Only install matching trim parts.
1
2
3
4
Plug 1.4404
1.4404
0,025 lin
Seat
kvs
4 711
1 Plug material
2 Seat material
3 K
VS
coefcient and characteristic
4 Consecutive number
Fig.2: Anti-rotation xture (on the trim)
NOTICE
!