Samson 3510 - 1 Safety Instructions and Measures

EB 8091-1 EN 5
Safety instructions and measures
1 Safety instructions and measures
Intended use
The SAMSON Type3510 Micro-ow Valve in combination with an actuator (e.g. Type3271
or Type3277 Pneumatic Actuator) is designed to regulate the ow rate, pressure or tempera-
ture of liquids, gases or vapors. The micro-ow valve is suitable for controlling low ow
rates, e.g. in pilot plants and technical research facilities. The valve with its actuator is de-
signed to operate under exactly dened conditions (e.g. operating pressure, process medi-
um, temperature). Therefore, operators must ensure that the control valve is only used in ap-
plications that meet the specications used for sizing the valve at the ordering stage. In case
operators intend to use the control valve in other applications or conditions than specied,
SAMSON must be contacted.
SAMSON does not assume any liability for damage resulting from the failure to use the
valve for its intended purpose or for damage caused by external forces or any other external
factors.
Î Refer to the technical data and nameplate for limits and elds of application as well as
possible uses.
Reasonably foreseeable misuse
The control valve is not suitable for the following applications:
− Use outside the limits dened during sizing and in the technical data
− Use outside the limits dened by the valve accessories mounted on the control valve
Furthermore, the following activities do not comply with the intended use:
− Use of non-original spare parts
− Performing service and repair work not described in these instructions
Qualications of operating personnel
The control valve must be mounted, started up, serviced, and repaired by fully trained and
qualied personnel only; the accepted industry codes and practices are to be observed. Ac-
cording to these mounting and operating instructions, trained personnel refers to individuals
who are able to judge the work they are assigned to and recognize possible hazards due to
their specialized training, their knowledge and experience as well as their knowledge of the
applicable standards.