Samson 3510 - Appendix; 10.1 After-Sales Service

EB 8091-1 EN 45
Appendix
2. Unfasten the valve or unbolt the ange
joint.
3. Remove the valve from the pipeline (see
section4.2).
Version with welding ends
1. Put the control valve out of operation (see
section9.1).
2. Cut the pipeline in front of the weld
seam.
3. Remove the valve from the pipeline (see
section4.2).
9.3 Removing the actuator
from the valve
See associated actuator documentation.
9.4 Disposal
Î Observe local, national, and internation-
al refuse regulations.
Î Do not dispose of components, lubri-
cants, and hazardous substances togeth-
er with your other household waste.
10 Appendix
10.1 After-sales service
Contact SAMSON's After-sales Service de-
partment for support concerning service or
repair work or when malfunctions or defects
arise.
E-mail
You can reach the After-sales Service De-
partment at aftersalesservice@samson.de.
Addresses of SAMSONAG and its subsid-
iaries
The addresses of SAMSON AG, its subsid-
iaries, representatives, and service facilities
worldwide can be found on the SAMSON
website, in all SAMSON product catalogs or
on the back of these Mounting and Operat-
ing Instructions.
Required specications
Please submit the following details:
− Order number and position number in
the order
− Type, model number, nominal size, and
valve version
− Consecutive number of installed trim
− Pressure, density, viscosity and tempera-
ture of the process medium
− Flow rate in cu.ft/min or m³/h
− Direction of ow
− Bench range of the actuator (e.g. 0.2 to
1bar)
− Is a strainer installed?
− Installation drawing