16
Samson AirLine
11. If you hear distortion at the desired volume level, first check to see whether the red “Peak” LED on the AR1 is lit. If it is not, make
sure that the gain structure of your audio system is correctly set (consult the owners manual of your mixer and/or amplifier for details).
If the red “Peak” LED
is lit, do the following:
• If you are using an AX1 handheld transmitter, use the supplied plastic screwdriver to turn its Microphone Input Level control
(trimpot) slowly counterclockwise (towards the “Min” position) until the distortion disappears.
• If you are using an AL1 body pack transmitter with its internal electret condenser microphone or an AH1 headset transmitter,
simply move the microphone further from your mouth. If you are using an AL1 with an external lavalier microphone, use the
supplied plastic screwdriver to turn the Gain control (trimpot) slowly counterclockwise until the distortion disappears.
Note that, following this setup procedure, you can always lower the Volume knob of the AR1 in order to attenuate the output signal if
necessary.
12. Conversely, if you hear a weak, noisy signal at the desired volume level, again make sure that the gain structure of your audio
system is correctly set (consult the owners manual of your mixer and/or amplifier for details) and that the Volume control of the AR1 is
fully clockwise. If it is and the signal coming from the AR1 is still weak and/or noisy, do the following:
• If you are using an AX1 handheld transmitter, use the supplied plastic screwdriver to turn its Microphone Input Level control
(trimpot) slowly clockwise (towards the “Max” position) until the signal reaches an acceptable level.
• If you are using an AL1 body pack transmitter with its internal electret condenser microphone or an AH1 headset transmitter,
simply position the microphone closer to your mouth. If you are using an AL1 with an external lavalier microphone, use the sup-
plied plastic screwdriver to turn the Gain control (trimpot) slowly clockwise until the signal reaches an acceptable level.
Setting Up and Using Your AirLine System
ENGLISH
To Next Page
Loading...
