Troubleshooting
4-14 Samsung Electronics
࡙ The indoor unit installation option are set to 020000-100000-200000-300000 by default.
࡙ Set the indoor unit option by wireless remote controller. When entering Address option, connect remote
controller receiver.
ÃϑϩɇɇϩͱͱΧϩͱϑ
SEG1 SEG2 SEG3 SEG4 SEG5 SEG6
0 2 Reserved
Use of external
temperature
sensor
Use of central
control
Compensation of
the fan RPM
SEG7 SEG8 SEG9 SEG10 SEG11 SEG12
1
Using of drain
pump
Reserved Reserved Reserved Remote control
SEG13 SEG14 SEG15 SEG16 SEG17 SEG18
2
Use of external
control
Setting the
output of
external control
S-Plasma ion Buzzer Control
Hours of filter
usage
SEG19 SEG20 SEG21 SEG22 SEG23 SEG24
3
Individual
control with
remote control
Heating setting
compensation
offset
The lowest
limit of outdoor
temperature
for heating
operation
Motion detection
sensor
Reserved
• Even if you set the Use of drain pump (SEG8) option to 0, it is automatically set to 2
(the drain pump is used with 3 minute delay).
• If you set the Maximum filter usage time (SEG18) option to a value other than 2 and 6,
it is automatically set to 2 (1000 hours).
• If you set an option to a value that is out of range specified above, the option is automatically set to 0 by default.
• The external output of SEG15 is generated via MIM-B14 connection. (Refer to the manual of MIM-B14.)
• If you set the Individual control with remote control (SEG20) option to a value other than 0 to 4,
it is automatically set to 0 (Indoor 1).
đߥǮɇцࢥ²ͱʪUЇʀϩࢥAͱϑͱʪ
To Next Page
Loading...