Troubleshooting
Samsung Electronics 4-35
Checking Comp Resistance (Normal Value)
U-V V-W W-U
AJ020TXJ2CH
AJ024TXJ3CH
ߡࢋߨߡߡࢋߩߡ ߡࢋߨߡߡࢋߩߡ ߡࢋߨߡߡࢋߩߡ
AJ020TXS3CH
AJ***TX*4CH
AJ***TX*5CH
ߡࢋߧߡߡࢋߨߡ ߡࢋߧߡߡࢋߨߡ ߡࢋߧߡߡࢋߨߡ
4-6-6 IPM Over current error
1. Check items
1) Is the cool ant changed?
2) Is the compressor running normally?
3) Is the compressor connected correctly?
4) Are there any obstacles near the indoor and outdoor units?
2. Check procedure
Yes
ŵʪͱЭʪϩ˵ʪͱɵϑϩɇʀʪϑɇʒϑϩɇ
the unit again.
No
Is the ourdoor unit unstalled correctly?
Yes
ŵʪͱЭʪϩ˵ʪͱɵϑϩɇʀʪϑɇʒϑϩɇ
the unit again.
No
Is the resistance
between pin1 and pin3 of the fan
࣍AĘߪߡߢ࣎ͱЭʪθߢ༯U
Yes
ĮΧʪϩ˵ʪЭɇЭʪࢋ
No
Ãϑϩ˵ʪЭͱϩɇ˝ʪ
between pin4 and pin3 of the fan (CN901)
ͱЭʪθߢߦǤࢌ
Yes
Check the compressor connection status.
No
Ãϑϩ˵ʪЭͱϩɇ˝ʪɵʪϩиʪʪ
pin5 and pin3 of the fan (CN901) during
the operation 1V~6V?
Yes
Yes
Yes
Yes
Replace the compressor.
Trun off the power and correct or replace
the temperature sensor location.
Trun off the power and reconnect the table.
Replace the compressor.
ŵʪΧɇʀʪϩ˵ʪЭʪθϩʪθťA9ࢋ
No
No
No
No
Is the fan running the operation mode?
Uͱʪϑϩ˵ʪЭͱϩɇ˝ʪ
between pin6 and pin3 of the fan (CN901) fluctuate?
(High 5V~6V, Low:0V~1V)
Are the temperature
sensor location and the measured
ЭɇЇʪͱθɇࢌ
Is the resistance
ЭɇЇʪɵʪϩиʪʪϩ˵ʪʀͱΧθʪϑϑͱθɵͱʒɇцɇʒϩ˵ʪʀ˵ɇϑϑϑ
in the range of Mega
Խ