Samsung AM DNMDKG Series - Setting Additional Functions of Wired Remote Control

41
English
Installation manual
Setting additional functions of wired remote control
Automatic Air-Volume
An Automatic Air-Volume function must be performed for each indoor unit with the wired remote control attached.
With its BLDC motor, you can use smart adjust the indoor unit fan speed depending on the installation condition.
If the duct is long so the external static pressure is high, or the duct is short so the external static pressure is low, the
Automatic Air Volume will automatically adjust the supply air flow to the rate air flow rate. Push the button to enter
the automatic air volume setting screen.
Indoor unit status information
ERV option
Ventilator
Discharge Temperature
Room Temperature Calibration
Service mode
Disabled
Automatic Air-Volume
Automatic Air-Volume
Stop
Operation
220V
Voltage
Press the OK button to complete the setting.
Status
OFF
Automatic Air-Volume
Run
Operation
220V
Voltage
Press the OK button to complete the setting.
Status
OFF
Automatic Air-Volume
Operation Voltage
Press the OK button to complete the setting.
Status
Run
220V
OFF
Automatic Air-Volume
Operation Voltage
Press the OK button to complete the setting.
Status
Run
230V
OFF
Indoor unit status information
ERV option
Ventilator
Discharge Temperature
Room Temperature Calibration
Service mode
Disabled
Automatic Air-Volume
[Option>Service mode] [Automatic Air-Volume]