Samsung AM DNMDKG Series - Setting an Indoor Unit Address and Installation Option; Setting Indoor Unit Addresses and Installation Options with Wired Remote Control

47
English
Installation manual
Setting indoor unit addresses and installation options with wired remote
control
Set the indoor unit address and installation option with the remote control option. Set each option separately since
you cannot set the ADDRESS setting and indoor unit installation setting option at the same time. You need to set twice
when setting the indoor unit address and installation option.
Setting an indoor unit address
1 If you want to use the various additional functions for your Wired Remote control, press the and buttons at the
same time for more than 3 seconds.
• The password entry screen appears.
2 Enter the password, “0202,” and then press the button.
• The settings screen for installation/service mode appears.
3 See the list of additional functions for the Wired Remote control on the next page, and then select the Address menu.
• Once you have entered the settings screen, the current setting appears.
• Refer to the chart for data setting.
• Using the / buttons, change the settings and press the button to move to the next setting.
• Press the button to save the new setting.
• Press the button to move to the Home screen.
NOTE
• While setting the data, you can press the button to move to the Home screen after checking the saving status at
a pop-up screen.
Indoor Unit/Ventilator Option
Address
Product Option
Installation Option 1
Installation Option 2
1
Address
-Move to ‘Address’ page.
2
Product Option
-Move to ‘Product Option’ page.
3
Installation Option 1
Move to ‘Installation Option 1’ page.
4
Installation Option 2
Move to ‘Installation Option 2’ page.
Setting indoor unit addresses and installation option