43
English
Installation manual
Setting the indoor unit option code with the wired remote control
To set the indoor unit option code use the wired remote control and follow the directions below.
0
Please enter your PASSWORD
Service mode
1 If you want to use the various additional functions for your Wired Remote Control, press the and buttons at the
same time for more than 3 seconds.
• The password entry screen appears.
2 Enter the password, “0202,” and then press the button.
• The settings screen for installation/service mode appears.
3 See the list of additional functions for the Wired Remote Control on the next page, and then select the Product option
menu.
• Once you have entered the settings screen, the current setting appears.
• Refer to the chart for data setting.
• Using the / buttons, change the settings and press the button to move to the next setting.
• Press the button to save the new setting.
• Press the button to move to the Home screen.
NOTE
• While setting the data, you can press the button to move to the Home screen after checking the saving status at
a pop-up screen.
To Next Page
Loading...
