Samsung AM DNMDKG Series - Page 52

Setting indoor unit addresses and installation option
52
English
Installation manual
Take the steps presented in the following table:
Steps Remote control display
1 Set the SEG2 and SEG3 values:
a Set the SEG2 value by pressing the (Low Fan) button repeatedly until the value you
want to set appears on the remote control display.
SEG2
b. Set the SEG3 value by pressing the (High Fan) button repeatedly until the value
you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in the following
order:
SEG3
2 Press the (Mode) button. Cool and On appear on the remote control display.
3 Set the SEG4 and SEG5 values:
a Set the SEG4 value by pressing the (Low Fan) button repeatedly until the value you
want to set appears on the remote control display.
SEG4
b. Set the SEG5 value by pressing the (High Fan) button repeatedly until the value
you want to set appears on the remote control display.
When you press the (Low Fan) or (High Fan) button, values appear in the following
order:
SEG5
4 Press the (Mode) button. Dry and On appear on the remote control display.
5 Set the SEG6 and SEG8 values:
a Set the SEG6 value by pressing the (Low Fan) button repeatedly until the value you
want to set appears on the remote control display.
SEG6