Samsung AM240MXVGNR/ET - Page 97

97
ENGLISH
Installing and setting the option with tact switch and explanation of the functions
Setting the option
1. Press and hold K2 to enter the option setting. (Only available when the operation is stopped)
ৄ If you enter the option setting, display will show the following. (If you have set the 'Emergency operation
for compressor malfunction', 1 or 2 will be displayed on Seg 4.)
ৄ Seg 1 and Seg 2 will display the number for selected option.
ৄ Seg 3 and Seg 4 will display the number for set value of the selected option.
2. If you have entered option setting, you can shortly press the K1 switch to adjust the value of the Seg 1, Seg
ߤɇʒϑʪʪʀϩϩ˵ʪʒʪϑθʪʒͱΧϩͱ࢏࣑ŵʪ˙ʪθϩͱΧɇ˝ʪϑߪߣߪߥ˙ͱθϩ˵ʪƊʪ˝Їɵʪθͱ˙ϩ˵ʪ˙Їʀϩͱ˙ͱθʪɇʀ˵ͱΧϩͱ࣒
Example)

3. If you have selected desired option, you can shortly press the K2 switch to adjust the value of the Seg 3,
Ɗʪ˝ߦɇʒʀ˵ɇ˝ʪϩ˵ʪ˙Їʀϩͱ˙ͱθϩ˵ʪϑʪʪʀϩʪʒͱΧϩͱ࢏࣑ŵʪ˙ʪθϩͱΧɇ˝ʪϑߪߣߪߥ˙ͱθϩ˵ʪƊʪ˝Їɵʪθͱ˙ϩ˵ʪ
function for each option)
Example)

4. After selecting the function for options, press and hold the K2 switch for 2 seconds. Edited value of the
option will be saved when entire segments blinks and tracking mode begins.
࡛Edited option will not be saved if you do not end the option setting as explained in above
instruction.
CAUTION
࢜
While you are setting the option, you may press and hold the K1 button to reset the value to previous
setting.
࢜
If you want to restore the setting to factory default, press and hold the K4 button while you are in the
option setting mode.
ৄ If you press and hold the K4 button, setting will be restored to factory default but it doesn't mean that
restored setting is saved. Press and hold the K2 button. When the segments shows that tracking mode is
in progress, setting will be saved.