Samsung C24B750X

33
Using Smart Station
NOTE
When using the LAN network of the Smart Station monitor or PC, ensure you connect the LAN cable to only
one of the two networks. If you connect the LAN cable to both networks, a system crash may occur.
1. Connect the LAN cable to the Smart Station monitor.
2. Set the network device of the Smart Station monitor to Enable using the Network
Settings menu.
NOTE
To enable the network device of the Smart Station monitor, go to Control Panel
→
Network and
Internet
→
Network and Sharing Center
→
Change adapter settings.
→
Select the Smart
Station monitor network device (displayed as LAN9512/LAN9514 USB 2.0 to Ethernet 10/100
Adapter).
→
Right-click on your mouse.
→
Select Enable.
3. Check that Obtain an IP address automatically is selected for the network device of
the Smart Station monitor in the network properties.
NOTE
To check that the network device of the Smart Station monitor is set to obtain an IP address
automatically, go to Control Panel
→
Network and Internet
→
Network and Sharing Center
→
Change adapter settings.
→
Select the Smart Station monitor network device (displayed as
LAN9512/LAN9514 USB 2.0 to Ethernet 10/100 Adapter).
→
Right-click on your mouse.
→
Select Properties.
→
Select Internet Protocol Version 4(TCP/IPv4).
→
Select Properties.
Static IP
To congure the IP address (private or ofcial) on your PC, someone (usually a server) must
allocate an IP address to the PC. An external IP address is allocated to you by your Internet
service provider. An internal IP address is allocated to you by your Internet router. You can
select whether to congure the IP address on the PC automatically or manually. The static IP
address mode is used to manually enter an IP address. The static IP address mode is suitable
if the IP address for the PC should not be changed (such as for a le sharing server) and
generally is not used, except under such special circumstances.
NOTE
When using the LAN network of the Smart Station monitor or PC, ensure you connect the LAN cable to only
one of the two networks. If you connect the LAN cable to both networks, a system crash may occur.
1. Set the LAN network on your PC to Disable using the Network Settings menu.
NOTE
To disable the LAN network on your PC, go to Control Panel
→
Network and Internet
→
Network and Sharing Center
→
Change adapter settings.
→
Select the network device of your
notebook PC.
→
Right-click on your mouse.
→
Select Disable.