Copying_ 64
Using a program’s setting
This option allows you to save the current settings for future use. You can
also use the previous settings from the last job.
Saving Programs
1. Press Copy from the display screen.
2. Adjust
the settings for each copy such as Paper Source, Duplex and
more in the Basic tab (see "Changing the settings for each copy" on
page 52).
3. Set the
copy features in the Advanced or Image tabs, if necessary (see
"Using special copy features" on page 55).
4. Pr
ess the Basic tab or Back.
5. Enter the
number of copies using the numeric keypad on the control
panel, if necessary.
6. Press Programs.
7. Pr
ess Save.
8. Press Program Name input area. The pop-up keyboard appears.
Enter the program name you want. Press Done.
You can see the values of set Programs by scrolling up or down
and check the values using the up/down arrows.
9. Press Save. When the confirmation window appears, the settings you
set are saved. Press OK to check the list or Cancel.
Loading Programs
1. Press Copy from the display screen.
2. Place the orig
inals face up in the DADF or place a single original face
down on the scanner glass and close the DADF (see "Loading originals"
on page 38).
3. Pr
ess Programs > Load.
4. Pre
ss a program name you want to use on the list.
5. Pr
ess Apply.
The machine is now set to copy according to the setting you selected.
6. Pr
ess Start from the control panel to begin copying.
Using the Quick Copy menu
The Quick Copy menu allows you to quickly set copy options without
having to move to a lower level menu or another tab. But, this menu does
not provide all copy options. If you need to use other copy options, use the
copy options in the Copy menu (see "Changing the settings for each copy"
on page 52 or "Using special copy features" on page 55).
1. Pres
s Quick Copy from the display screen.
2. Place the originals face up in the DADF or place a single original face
down on the scanner glass and close the DADF (see "Loading originals"
on page 38).
3. Adjust the settings for each copy such as Reduce/Enlarge,
Duplex/N-Up, Output, Paper Source, etc.
You can set the default Quick Copy options from Machine Setup
> Application Setting > Copy Settings from the display screen.
Set the most frequently used settings.
4. En
ter the number of copies using the numeric keypad on the control
panel, if necessary.
5. Pres
s (Start) from the control panel to begin copying.
To Next Page
Loading...
