Copying_ 57
8. Press Start on the control panel to begin copying.
• If the original is larger than the printable area, some portions may
not be printed.
• If you do not press the Start button, only the front side will be
copied.
• If you press the Stop button, the machine cancels the copy job
and returns to ready mode.
N-up copying
The machine reduces the size of the original images and prints 2 - 9 pages
onto one sheet of paper.
• When you use this option Auto Fit, ID Copy, Booklet and Book
Copy in the Advanced tab are inactivated.
1. Press Copy from the display screen.
2. Place the orig
inals face up in the DADF or place a single original face
down on the scanner glass and close the DADF (see "Loading originals"
on page 38).
3. Pr
ess Advanced tab > N-Up from the display screen.
4. Pre
ss an option according to how many images to copy onto one page.
• Off: Copies an original onto one sheet of paper.
• 2Up
- 9Up: Copies corresponding numbers of separate originals to
one page.
Depending on original document size, output paper size, and the
reduced rate of image, some options may be inactivated.
5. Select a tray in Paper source.
6. Pre
ss the appropriate page order.
• Dep
ending on the options you select, the result will vary. Refer to the
below table before using the 2Up option.
To Next Page
Loading...
