2-3
Setting Parameters
The procedure for setting parameters takes you through the top level menus for
Network, Load & Upgrade, System and Server.
Network Menu
• Select ‘2.Network’. You see:
• Select ‘1.Mode’. You see:
• Select ‘1.Manual IP’ to manually enter the IP, Subnet Mask, and Gateway IP
addresses and continue with this section.
OR
Select ‘2.DHCP’ to have the IP, Subnet Mask, and Gateway IP addresses
automatically entered for you (and then go to the section Load & Upgrade
Menu to continue).
If you selected ‘1.Manual IP’ you see:
followed by:
>1.Mode
2.IP
>1.Manual IP
2.DHCP
Manual IP
Selected
>1.Mode
2.IP
To Next Page
Loading...
