A-3
Entering Characters on the LCD Panel
Alphabetic characters are entered on the LCD panel using the dial buttons (button
2=ABC, button 3=DEF, and so on). Press a button the number of times to select
the required character (e.g. press “2” three times for “C”). Pressing a different
button moves the cursor to the right to allow you to enter the next character.* For
example, if the text to enter is “SAM SMITH”, press the number “7” four times to
get the letter “S”; now press the number “2” once to get the letter “A” Continue
selecting characters from the keypad to complete your entry. Press the
programmable “A” button to toggle between upper and lower case text (see
below).
* Tip
: When the character you want is on the same key as the previous character you
typed in, press the [Volumet] button to move the cursor to the right, then select the
character.
Enter characters as shown in the following table.
No. of presses
Dial button
1 2 3 4 5
0 Q Z . ) 0
1 Space ? , ! 1
2 A B C @ 2
3 D E F # 3
4 G H I $ 4
5 J K L % 5
6 M N O ^ 6
7 P Q R S 7
8 T U V * 8
9 W X Y Z 9
* : = [ ] *
To Next Page
Loading...
