22
PROGRAM PERSONAL SPEED DIAL
NAMES FOR OTHER STATIONS
Each individual station user can program his/her own names but in cases
where it is impractical or for single line telephone users, this program allows
a system administrator to view or change any station’s speed dial names.
The station speed dial codes are 00–49. Each station begins with ten num-
bers (00–09) and can be assigned more in blocks of ten up to a maximum
of fifty numbers.
PROGRAM KEYS
UP & DOWN - Used to scroll through extension numbers and speed dial bins.
KEYPAD - Used to enter selections.
SOFT KEYS - Move cursor left and right.
Speaker - Used to store data and advance to next program.
Hold - Used to clear previous entry.
Redial - Used to select ALL.
ACTION DISPLAY
1. Press TRSF and then dial 106 [2
01] SPEED NAME
Display shows 00:
2. Dial the station number (e.g., 205) OR [2
05] SPEED NAME
press UP or DOWN to select the station 00:
and press the right soft key to move the
cursor
3. If the selected station has no speed dial [205
] SPEED DIAL
bins, this display will be shown and a new NO SPEED BLOCK
station may be selected
4. Dial the speed dial location (e.g., 05) OR [205] SPEED NAME
use UP or DOWN to scroll through the 01:_
location numbers and use the right soft
key to move the cursor OR press the left
soft key to return to step 2 above
5. Enter the name using the procedure in [205] SPEED NAME
Program Station Names
and press the 01:SAM SMITH
right soft key to return to step 2 OR
press the left soft key to return to step 3
21
Open customer programming and follow the instructions below.
ACTION DISPLAY
1. Press Transfer and then dial 105 [201] SPEED DIAL
Display shows 00 :
2. Dial the station number (e.g., 205) OR [205] SPEED DIAL
press UP or DOWN to select the station 00
:
and press the right soft key to move the
cursor OR press the left soft key to go
to step 4
3. If the selected station has no speed dial [205] SPEED DIAL
bins, this display will be shown and a new NO SPEED BLOCK
station may be selected
4. Dial the location number (e.g., 05) OR [205] SPEED DIAL
press UP or DOWN to select the location 05: _
and press the right soft key to move the
cursor OR press the left soft key to return
to step 2
5. Enter the trunk access code (e.g., 9) [205] SPEED DIAL
followed by the number to be dialed 05 : 9-4264100_
(e.g., 4264100) OR press the right
soft key to return to step 2 OR press the
left soft key to return to step 3 OR press
Hold to clear an entry (if an error is made,
use the DOWN key to step back)
6. Press the F key to access Program Station
Speed Dial Names OR press Transfer to save
and exit programming OR press Speaker to save
and advance to the next program
DEFAULT DATA: NO SPEED DIAL NUMBERS PROGRAMMED
To Next Page
Loading...
