Section 1: Getting Started
This section explains how to start using your phone by first
configuring your hardware, activating your service, and then
setting up your voice mail.
2. Lift the cover up (2) and to the right of the phone.
Setting Up Your Phone
Prior to use it is necessary to install both the battery and SIM
into their corresponding internal compartments. The
microSD™ card slot is also located in this same internal
area.
1. Remove the back cover by inserting a fingernail
into
the slot on the top of your phone (1).
Caution!
Do not remove the rubber seal from the inside of the
back cover. Doing so can cause water damage to the
device if it gets wet.
Do not bend or twist the back cover excessively.
Doing so may damage the cover.
6
To Next Page
Loading...
