Samsung HW-S60D User Manual

ENG - 9
󱂕
(Mute)
Press the (Mute) button to mute the sound.
Press it again to unmute the sound.
LED
Indicator
Blinks X Repeatly
󱂖
Volume
Push the button up or down to adjust the volume.
LED
Indicator
White moves to right X1
Volume Up
White moves to left X1
Volume Down
󱂗
CH LEVEL
By pressing the button, you can adjust the volume of each speaker.
LED
Indicator
White Blinks X1
“Center Level”  “Side Level”
– If the Rear Speakers (sold separately) are connected, the setting “Rear Level” is supported. Use the
Up/Down button to adjust the volume of the “Rear Level” between -6 to +6.
󱂘
(Sound Control)
By pressing the button, you can set the audio function. The desired item can be adjusted using the Up/
Down buttons. Each time the mode changes, the Multicolor LED blinks in white.
LED
Indicator
White Blinks X1
“SpaceFit Sound”  “ Active Voice Amplier”  “Voice enhancement”  “Night
mode”  “Sync”  “Virtual”
– Press and hold the (Sound Control) button for about 5 seconds to adjust the sound for each
frequency band. 150Hz, 300Hz, 600Hz, 1.2kHz, 2.5kHz, 5kHz, and 10kHz are selectable using the Left/
Right buttons and each can be adjusted to a setting between -6 to +6 using the Up/Down buttons.
(Make sure the Sound mode is set to "Standard".)
– If the Rear Speakers (sold separately) are connected, the setting “Sound Grouping” and “Private Rear
Sound” are supported.
– Refer to “Setting the (Sound Control)” on page 11.

Samsung HW-S60D Specifications

General

Brand	Samsung
Model	HW-S60D
Category	Speaker System
Language	English