5.4. P/T Setting
5.4.1. Pan Limit
The moving range in the Pan direction can be limited.
Position : Moving range can be set up. Set the position from the
left. The stop position may change due to the initialization by
such operation as power resumption depending on position
setting. This does not mean it is out of order.
On/Off : When this function is on, the limit is effective. Default
setting is Off.
5.4.2. Tilt Limit
Moving range in the tilt direction can be limited.
Position : Moving range can be set up. Set the position from the
top direction. The stop position may change due to initialization
by such operation as power resumption depending on position
setting. This does not mean it is out of order.
To Next Page