Channel Control
Selecting the Antenna
t. Press the MENU button to display the menu.
Press the A or _' button to select "Channer', then press the ENTER button.
2. Press the ENTER button to select "Antenna".
Press the A or _r button to select "Air" or "Cable", then press the
ENTER button.
Press the EXiT button to exit.
:_ f the antenna is connects _to ANT 1 tN (AIR_.
seiec[ 'Air" and if it is connected to ANT 2 N
'CABLEI. select "Cable.
> fbothANT1 N AIR anaANT2tN CABLE/ _::';"_#_'
are connec,ec selec]:me amenna input you want. _
f the antenna mpu[ is no[ selected properly, noBe _
"nay appear on the screen.
Pressthe ANTENNA button on the
remote control.
Clearing Scrambled Channels - Digital
The Clear Scrambled ChanneI function is used to filter out scrambled channels after Auto Program is completed.
It removes the scrambled channels from the list by tuning the digital cable channels. This process may take up to 20~30 minutes.
t. Press the MENU button to display the menu.
Press the A or _' button to select "Channel", then press the ENTER button.
2. Press the A or T button to select "Clear Scrambled Channel", then press the
ENTER button.
It searches scrambled channels, which are to be removed from the list.
To stop searching scrambled channels;
Press the ENTER button to select Stop.
Press the 4 button to select "Yes", then press the ENTER button.
3, When the scrambled channel searching is completed, press the ENTER button.
Press the EXIT button to exit.
Only cable mode is available.
To Next Page
Loading...
