1. Check the Solenoid by using
DCU diagnostic mode 06.
2. Check if the pad is loose due
to bad sealing of the side-pad.
3. Check the surface of the
roller-pickup for foreign matter.
4. If the paper
feeds into the printer rand
Jam 0 occurs, perform DCU to check
feed-sensor of the
engine board.
Replace the solenoid.
Replace the side-pad Assembly L
or R, if necessary.
Clean with soft cloth dampened
with IPA(Isopropyl Alcohol) or
water.
Replace the SMPS, HVPS or
Sensor.
• Description 1. Paper is not exited from the cassette.
2. Jam-0 occurs if the paper feeds into the printer.
To Next Page
Loading...
