3. Paper is accordion in the fuser.
2. If the paper is
rolled in the Fuser Roller:
• This occurs when a Guide claw is
broken away or transformed.
• It occurs when the Spring of a Guide claw
is broken away or transformed.
• It occurs when the Heat-Roller or
Pressure-Roller is seriously
contaminated
with the toner.
If the paper is stuck in the fuser :
disassemble the fuser and remove
the jammed paper, and clean the
surface of the pressure roller with
dry gauze.
Remove the jammed paper after
disassembling the fuser : Clean the
surface of the pressure roller with
dry gauze.
• Remove the toner particles
stained on the rib.
• Check the assemblage and
performance of the exit.
• Description 1. Recording paper is jammed in front of or inside the fuser.
2. Recording paper is stuck in the discharge roller and in the fuser just after passing through the
Actuator-Feed.
To Next Page
Loading...
