Service Manual
Alignment & Troubleshooting
4-38
Samsung Electronics
2) The printer is not working (2)
• Description
After receiving the printing order, no response at all or the low speed of printing
occurs due to wrong setup of the environment rather than malfunction of the printer itself.
1. Secure more space of the hard disk.
2. Printing error occurs even
if there is enough space in
the hard disk.
3. Check the parallel-port-related
items in the CMOS Setup.
4. Reboot the system to print.
Not working with the message 'insufficient printer
memory' means hard disk space problem rather
than the RAM problem. In this case, provide more
space for the hard disk. Secure more space using
the disk utilities program.
The connection of the cable and printer port is not
proper. Check if the connection is properly done
and if the parallel port in CMOS is rightly set up.
As a printer port, Select ECP or SPP among
SPP(Normal), ECP, and EPP modes(increase
printing speed) SPP normal mode support 8-bit
data transfer, while ECP Mode transfer the 12-bit
data.
If the regular font is not printing, the cable or the
printer driver may be defective.
Turn the PC and printer off, and reboot the system
to print again. If not solved, double-click the printer
in my computer If the regular fonts are not printed
this time again. the cable must be defective so
replace the cable with new one.
To Next Page
Loading...
