P
RINTING
T
ASKS
4.26
Using the Status Monitor
If an error occurs while printing, the Status Monitor window
appears, showing the error.
NOTE
s:
• The Status Monitor program can only be used if you connect the
printer to your computer with the USB cable, or on the network.
• You can use the Status Monitor in Windows 98/Me/NT 4.0/2000/
XP.
Installing Status Monitor
1
Insert the supplied CD-ROM into your CD-ROM drive.
The CD-ROM should automatically run and an maintenance
window appears.
If the maintenance window does not appear, click Start and
then Run. Type X:\Setup.exe, replacing “X” with the
letter of your drive and click OK.
NOTE:
If your machine is not connected to the computer, the
following window will appear.
• After connecting the machine, click Next.
• If you want to skip the connection status, click Next, and No to
the following screen.
2
Click Custom.
If you have been installed the printer driver before, click
Repair.
3
Click Status Monitor and then click Next.
4
When the installation is completed, click Finish.
To Next Page
Loading...
