Service Manual
Alignment & Adjustments
4-12
Samsung Electronics
4.2.1 Clearing Paper Jams
Note : When removing paper that is jammed in the printer, if possible always pull the paper in the direction that it normal-
ly moves so as not to damage internal components. Always pull firmly and evenly; do not jerk the paper. If the paper
tears, ensure that all fragments of paper are removed; otherwise a jam will occur again.
When a paper jam occurs, the Status LED lights red. Open and close the top cover. The jammed paper automatically exits
the printer. If the paper does not exit, check the display on the control panel. The message indicating the corresponding
location of the paper jam appears. Refer to the table below to locate the paper jam and to clear it:
4.2.1.1 In the paper feed area
• In the Tray1
1. Pull the tray 1 open. 2. Remove the jammed paper by gently pulling it straight
out. Make sure that all of the paper is properly aligned
in the tray 1.
If the paper does not move when you pull, or if you do
not see the paper in this area, check the fuser area
around the toner cartridge.
3. Insert the tray 1 into the printer until it snaps into
place. Printing automatically resumes.
To Next Page
Loading...
