6.2.13 Stains on the Back of Page
• Description The back of the page is stained at 55 or 126 mm intervals.
Digital
Digital Pri
Digital Printer
Digital Printer
Digital Printer
Check and Cause Solution
1. 55mm : Transfer roller is contaminated.
2. 126mm : Pressure roller is contaminated.
1.1. Perform the OPC Cleaning Mode Print 2
or 3 times. Run Self-Test to remove the
contamination of the transfer roller.
1.2. Replace the transfer roller if contaminated
severely.
2.1. Perform the fuser cleaning mode print 2 or
3 tiones.
2.2. Disassemble the fuser and clean the
H/R(Heat Roller) and P/R(Pressure roller).
And check the area between H/R and
Thermistor. If contaminated, clean the
area not to be deformed.
6.2.14 Blank Page Print out (1)
• Description Blank page is printed.
Check and Cause Solution
Bad ground contacts in OPC and/or
print
cartridge.
1.
Check if
the Ground-OPC
is defective(
set
inside left side).
2. Remove contamination of the terminals of
the
print
cartridge and the unit.
6.2.15 Blank Page Print out (2)
• Description
1. Blank page is printed.
2. One or several blank pages are printed.
3. When the printer turns on, several blank pages print.
Check and Cause Solution
1. Bad ground contacts in OPC and/or
print
cartridge.
2. Abnormal solenoid.
1. Remove contamination of the terminals of
the
print
cartridge.
2. Perform the engine self test using EDC Mode to
check if the Solenoid is normal.
3. If not solved by the above directions 1-2,
Replace the engine board.
4. Turn the power off, delete the data of PC
and try printing again.
Service Manual
Troubleshooting
6-8
Samsung Electronics
To Next Page
Loading...
