Service Manual
Alignment & Adjustments
4-20
Samsung Electronics
LSU Motor Error A problem has occurred in the LSU Unplug the power cord and plug it back in.
Cycle Power (Laser Scanning Unit). If the problem persists, please call for
service.
MP Tray There is no paper in the multi-purpose tray. Load paper in the multi-purpose tray.
Paper Empty
OPC is Cleaning Your printer is printing a cleaning sheet now. Please wait a few minutes.
Open Heat Error There is a problem in the fuser unit. Unplug the power cord and plug it back in.
Cycle Power If the problem persists, please call for
service.
Out-Bin Full The output tray is full. It can hold up to 250 sheets of plain
paper. Once the paper is removed from
the output tray, the printer resumes
printing.
Over Heat Error There is a problem in the fuser unit. Unplug the power cord and plug it back in.
Cycle Power If the problem persists, please call for
service.
Paper Exit Jam 1 Paper has jammed before reaching Clear the jam.
Open/Close Door to the exit sensor.
Paper Jam 0 Paper has jammed in the feeding area Clear the jam.
Open/Close Door of the tray.
Paper Jam 1 Paper has jammed in the fuser area. Clear the jam.
Open/Close Door
Paper Jam 2 Paper has jammed in the paper exit area. Clear the jam.
Check Inside
Paper [Tray] Jam Paper has jammed in the displayed Clear the jam.
Open [Tray] optional tray.
Printing... The printer is printing jobs. Complete your printing.
Ready The printer is on-line and ready to print. Use your printer.
Replace Toner This message appears between the Toner Replace the toner cartridge with a new
Empty status. one.
Self Diagnostic The LSU (Laser Scanning Unit) in your Please wait a few minutes.
LSU printer is checking some problems
detected.
Self Diagnostic The engine in your printer is checking Please wait a few minutes.
Temperature some problems detected.
Sleeping... The printer is in power save mode. When data is received, it switches to
on-line automatically.
Message Meaning Suggested solutions
To Next Page
Loading...
